ProGuard™ Preserved Wood
IntroductionHandling and UseApplication InformaitonFencesDecksWarranty InformationHelpful SitesFrançais


Lattice Panel Fence

This novel design incorporates lattice as a vertical component. The centre portion is made of alternating boards. It gives good ventilation and provides an interesting addition to any yard.

Bill of materials
for a section 8’ wide x 6’ 6” high

Posts 2 - 4” x 4” x 12’
or 2 - 6” x 6” x 12’
Cap 1 - 2” x 6” x 8’
Rails 2 - 2” x 4” x 8’
Boards 16 - 1” x 6” x 6’
Lattice 2 - 1’ x 8’
Lattice Nailers 8 - 3/4” x 3/4” x 8’
or Grooved 4 - 1” x 2” x 8’


4 fence brackets
Nails or screws

Other simple fence plans:
Simple Board Fence
Alternating Board on Board Fence
Lattice Top Fence

06/03
Back


Before You Begin

ProGuard™ Preserved Wood
 

This is not a final design or plan. You are responsible for code approval and the final design. Check with a building code official or a building expert to make sure that the materials and construction methods shown are suitable to your situation. Home Depot and Timber Specialties Co. assume absolutely no responsibility for the correct use of this information. Plans should be examined by a professional before starting construction.

CLOSE

ProGuard products are produced by independently owned and operated wood preserving facilities.
Premium Cut and ProGuard are trademarks of Home Depot. NatureWood is a registered trademark of Timber Specialties Co.

© All materials on this website are copyright protected and the property of Timber Specialties Co. For permission on reprinting or reproducing any materials please e-mail the webmaster with your requests. Copyright © 2003 Timber Specialties Co. All rights reserved.